Condensation on WINDOWS

Formation of condensation on the surface of the glass to the room and the window frames.

Generally, condensation can occur on the surface of the glass from the room, window frames, respectively. Then I spoke to sweat or fogging of the window. This however should not be confused with the occurrence of condensation inside the glass / when condensation between two glass panes inside the glazing, it is defective and should seek the intervention of specialized service /.

In residential areas continuously releases water vapor can be taken the following amounts:

- Air exhaled by a person: daily amount of 1 to 2 liters

- Cooking time: up to 2 liters a day for a family of four

- Bathing, watering flowers, washing, etc..: A day to 3 liters for a family of four.

Condensation starts at the end of the glass as the coldest part of the dwelling. Besides the wide window sills, and a frame wing may hinder air flow, so that moisture in the bottom of the glass may occur earlier than in the middle.

Condensation can occur in unheated rooms. The reason is the gradual cooling of the room at night and saturation of air with water vapor by breathing at relatively low temperature.

Condensation may occur not only windows, but all the cold places in the room. This leads to mold and mildew stains on the walls.

Subject to certain rules condensation can be reduced or disappear.

1. To be more ventilated rooms where condensation. However, this should be done by continuous ventilation / opening valve /.

2. Ventilation through a wide open window saves energy and prevents condensation and mold. The windows open wide for 5-10 minutes, off heat, so saturated with water vapor air is replaced with a new cooler. This should be done three or four times a day.

3. The premises on the north side should be given particular attention, because in winter they get cold faster than the southern. It is good to keep temperatures 17-18 degrees.

4. To maintain the lowest possible temperature differences between different rooms in the house.

5. Preferably in the morning room to be ventilated at least 20 minutes after opening the windows to ensure a continuous heating.

6. Avoiding condensation can be avoided by changing the flow of warm air.

7. In the absence of heater situation becomes favorable for the formation of condensation and mold.

8. If possible, heating is not switched on and off to maintain a relatively uniform temperature throughout the day.

How to care for PVC windows?

Usually, changing windows and repair of the dwelling coincide. New windows modify the interior of the dwelling mode of ventilation, heat and microclimate. Proper operation will provide optimal conditions for life and maximum use of PVC.

Maintenance of PVC windows

It is periodically lubricate all hinges and locking mechanisms on windows and doors. We must not allow to enter the sand, lime, mortar, etc.. pollutants in the mechanisms. On the seals should not prevent the accumulation of dust. There are special chemicals that protect the rubber seal from the weather and make them more flexible. The windows are made of plastic profiles, which are resistant to sunlight and weathering. For white profiles are preparations that clean adherent dust accumulated over time.

Airing the home

Commonly used to date wooden doors and windows do not close tightly. This unpleasant fact has some advantages. Cool air penetrating indoor warms and absorbs moisture.The flow does not allow ingress of moisture on the inside of windows.

New windows are closed very tightly … They make your home warmer, protect it from street noise, reducing the required heating energy. Along with this, to prevent the occurrence of natural currents and prevent the reduction of moisture in the room. Create conditions for the occurrence of condensation on the coldest, exterior walls of the house who have contact with cold air. For these reasons, the house should be aired more often than in the presence of wooden windows by opening the windows and turn on fans in the bathroom and toilet.

Occurrence of moisture
The premises are divided into dry and moist. To apply wet kitchen, bathroom, strange as it seems the bedroom. In the kitchen arises moisture, cooking, bathroom – for bathing, washing, drying clothes. In the bedroom the occurrence of moisture is associated with sleep. During sleep each person exhales in 1 to 2 liters of water. Moisture is particularly intense in the bedroom, where the air temperature is lower than in other areas.Condensation on windows and on those aspects of furniture that are facing the outer walls. To reduce condensation, regularly ventilate the bedrooms.

Condensation

Condensation may occur on the surface from space, glazing, window frames, respectively. Then I spoke to sweat or fogging of the window. This however should not be confused with the occurrence of condensation inside the glass – where condensation between two panes of glass, it is defective and should seek the intervention of specialized service. Condensation starts at the end of the glass as the coldest part of the dwelling.
Condensation can occur in unheated rooms. The reason is the gradual cooling of the room at night and saturation of air with water vapor by breathing at relatively low temperature. Condensation may occur not only windows, but all the cold places in the room. This leads to stains, mold and mildew on the walls. Subject to certain rules condensation can be reduced or disappear.